Its common to see on many ecig forums about having problems trying to get the Wismec RX200 mod to fire up. Users are getting a common 'Atomizer Low' message appear on the screen and the tank it not vaping. Let me explain why this is happening first before i provide a solution. There is a short taking place some right from the 510 connector on the mod to the coil inside the tank. A short is when an electrical connection is not making the correct contact with the right terminals. In vaping, a short can occur for many reasons, it could be leaking ejuice that has cause a bad connection on the bottom of the tank or it could be a loose coil. We have provided in this article the common RX200 atomizer low fixes to help you get your not working ecig back on the road again.
1) Remove the tank from the mod. Clean the 510
connector on the mod and the bottom of the tank. If you have overfilled your
vape tank, the ejuice can spill into the bottom of the bottom and gather up in
the connector. Clean contacts and try again.
2) Take the tank apart and remove the coil clean
the bottom end with a tissue and reinsert it back into the base. The coil could
become loose overtime or gunked up from over vaping. If this doesn't make any
kind of difference, try inserting a brand-new coil into the tank and see if it
fixes the atomizer low problem.
3) Try the tank on another mod. If its works on a
different one but not your RX200 then the problem is with the mod itself. You
can try updating the firmware, but in most cases its a hardware problem. You
can try inspect the problem by opening the mod and checking if the two wires
are soldering on the connection properly. It could be the connector itself
which you could possibly change.
(Remember if your Wismec RX200 is still under warranty, its best not to open it up and just send it back to the provider) In most cases the will offer you are refund or provide you with a replacement.
0 comments:
Post a Comment