If you are regularly smoking medical marijuana, also known as cannabis, then
breaking up the main bud into different little parts can be a tricky process. Breaking it up with your hand
is possible, however, most of the time the
small pieces can be uneven, making it hard to fit into the bowl of a bong and
your hands will remain sticky. A grinder is a tool that is used to break large
parts of cannabis leaves into smaller parts. A good quality grinder can
sometimes be costly and assumed that you won't need it, but it really does come
in handy when it’s time for some weed and you are short of time. Grinders may
look all the same, however, they are made
from different materials. The plastic ones usually break on you after a while
and can make a rather unpleasant squeaking noise when you are grinding away your cannabis from your local buy cannabis seeds in New Zealand vendor.
I
would personally recommend that best-constructed
grinder are made from either zinc or aluminum,
regardless of which company produces them. The metal grinders can last forever,
but to ensure that they keep working through the years, you will need to clean
it regularly. Once you have selected the medical
cannabis that you want to grind, use the instructions below to help you with
this. It’s a very simple process and as you keep doing it for each session you
will become a pro at the time. Its suggested that if it is your first time, you
use the grinder over a table, that way if you accidentally open it the wrong
way, you won't lose any cannabis, as it can be a pain to pick up off the floor.
1) Remove the top lid from your grinder that you want to use. Use your
fingers to break the large parts of the buds of the medical cannabis purchased from Marijuana seeds NZ and place around
the center around into the grinders teeth. Try to evenly distribute
the cannabis around the teeth of the grinder. You want it all the parts to be
broken down evenly.
2) Place the top back on that you lifted off earlier on. Using both of your
hands, rotate it around eight to ten times. The more you do it the better, while
you are doing this, the small parts of the bud will fall down the little holes
inside the grinder. I always recommend that you remove the top lid, to check
that there are no pieces stuck in the
teeth that haven't been broken yet, as
you don't want to be wasting any weed. If there are some big pieces, simply
break them with your finger and place them back in to be ground again.
2) You're nearly there. All you need
to do now is unscrew the chamber to gain access to the ground parts of the cannabis leaves, found in the bottom part and
transfer it into your bong, joint, blunt or vaporizer.
That’s all there is to using a weed grinder. It is very simple once you get
the hang of it and can make your life easier when it comes to getting your
devices ready.
0 comments:
Post a Comment